MODEL NO: 491125

Rheem 125L Electric Water Heater

12

YEAR
WTY

No frills. No fancy features. The 125L is the perfect Rheem electric water heater for smaller families on a budget.

Features at a Glance

Capacity (L)
135
No. of People
2-3  continuous
Energy Rating
n/a

To install a Rheem, you'll need a plumber

Get in touch with your local Rheem Approved Plumber and ensure your install is done right.

  • Small diameter -480mm
  • Exclusive Rheem Ultranamel ® Class Y enamel protects the cylinder with a tough, durable coating.
  • Feature dual handed inlet and outlet fittings — for easy installation.
  • Dual handed connections
  • Mains pressure — so you can run the tap and the dishwasher at the same time.
  • 12 year cylinder warranty*
  • 1 year labour warranty on the cylinder*
  • 1 year parts and labour warranty on all other components for domestic (non-commercial) installations*

*Warranty conditions apply.

To obtain a quote on this product

Call Rheem on


Ready to buy a Rheem?

For help to make the right choice, access our network of Rheem Approved Plumbers and Stockists.


Top Five Troubleshooting Topics


The flow of hot water is not adequate to keep the water heater operating. This can be caused by flow restrictors and water saving low flow taps. You’ll need to have a plumber increase your hot water flow rate to a minimum of two to three litres per minute. To find your local Rheem Approved Plumber, contact us  or call Rheem Service on 1300 556 036.  

The error code is displayed in the room temperature display. Please refer to the below listing to see what your error codes means, then call Rheem Service to book a service call on 13 10 31.

 

Error Code

Fault Condition

Action

03

Filter damage

 

 

 

 

 

 

BOOK SERVICE CALL WITH RHEEM SERVICE

PH: 13 10 31

05

Filter not cleared

11

Ignition Failure

12

Flame Failure

14

Thermo Switch Off (150⁰C)

Overheat Thermistor temp. too high

16

Room temp. too high

(40⁰C  10 min)

22

Tip-Over switch operate

31

Room temp. thermistor abnormal

33

Overheat thermistor abnormal

62

Abnormal fan speed

71

Gas solenoid valves circuit abnormal

Gas proportional control valve circuit abnormal

72

Detected false flame

Thermocouple circuit abnormal

73

Functional trouble on gas type circuit

 

 

H: High

L: Low

SW: Switch

Please see the Owner Guide for your Storage Water Heater model.

Please see the Owner Guide for your Storage Water Heater model and our gas relighting videos. 

Please contact your electricity provider to confirm the times when you pay off-peak, shoulder and peak tariffs for your electricity. Your water heater will be connected to an appropriate tariff (timed control), depending on its capacity, to ensure you have sufficient hot water for your needs. Twin element water heater models have the added benefit of using off peak tariffs to save money whilst providing an extra boost should it be needed. Please see the Owner Guide for your Storage Water Heater model.


Is the gas connection only used for the Water Heater?

Please, select all the fields

Running Cost Estimator Disclaimer as at 23/10/2017

Things that you should know about the Rheem Running Cost Estimator

The estimator is provided as a guide only to help you compare estimated running costs between various water heater types.

The estimator is based on Australian Standard AS5263, which relies on certain assumptions, such as an average daily load of 200L and 19 tap turns. Your situation and usage may be different to these assumptions, so the estimator may not match your actual daily loads and pattern of use.

Accordingly, the estimator cannot and does not purport to provide an accurate assessment of your yearly hot water energy bill. It does, however, allow a reasonable comparison between various water heater types based on Australian Standard AS5263 and average fuel tariffs used in the estimator.

Your state has been used to determine the temperature rise required to heat water from cold to a temperature of 65C, the applicable charge for the tariff type selected and the amount of solar savings.

Solar savings are based on Australian Government approved modelling for the type of solar water heater selected and the booster type. All electric boosted solar water heaters are modelled with a continuous tariff, but may be suitable for use on other tariff types depending on the model selected, your climate zone and the amount and usage pattern of hot water use.

Tariffs are current as at 1st July 2017 and represent an average price for the fuel type for the capital city in the state or territory, including GST.

Fixed charges, system access charges, delivery fees and any other fees and charges, including special rates and discounts are excluded from the estimator.

Energy consumption figures used are for a typical water heater within a category and do not reflect a specific model. Actual energy use may vary.

Heat Pump and solar water heaters may be suitable for Off Peak/Shoulder Rate tariffs depending on the type of water heater selected and the location. You should consult with your energy provider or installer before making any decision.

Rheem Ultranamel Electric 80-400L Jul 2018


Rheem 400L Electric Water Heater

Designed and manufactured in Australia the Rheem 400L Electric Water Heater is the ideal replacement for your old electric water heater.

Rheem 315L Electric Water Heater

This Electric Water Heater is the ideal replacement for your old electric model.

Save when switching to solar


To install a Rheem, you'll need a plumber

Get in touch with your local Rheem Approved Plumber and ensure your install is done right.


Ready to buy a Rheem?

For help to make the right choice, access our network of Rheem Approved Plumbers and Stockists.