MODEL NO: 511410

Rheem Loline® 410L Solar Water Heater

5

YEAR
WTY

  • Do your bit for the planet and save energy at the same time! Go solar with the Rheem Loline® solar hot water heater. It's designed for warmer climates and areas with good water quality.

  • If you need an emergency replacement, you can run this water heater on its electic boost until your collectors are installed.

Features at a Glance

Capacity (L)
410
No. of People
3-7  continuous
Frost protected
No

To install a Rheem, you'll need a plumber

Get in touch with your local Rheem Approved Plumber and ensure your install is done right.

  • 410L capacity tank is suitable for 3 — 7 people
  • If the sun is not shining you will never run out of hot water with the electric booster
  • Reduces energy use1 2
  • Suitable with NPT or LCS collectors
  • 5 Year Warranty*
  • 5 year cylinder, 5 year collector(s), 3 year labour on cylinder, 1 year parts including labour. Applies to domestic installations only. Amended warranty may apply where a government rebate has been received for the solar water heater. Phone 131 031 for details

*Warranty conditions apply.

1 Energy reduction based on Australian Government Approved TRNSYS simulation modelling and apply when replacing an electric water heater with a Rheem solar water.

2 Any financial savings will vary depending upon type of Rheem Solar system installed, orientation and inclination of the solar collectors, type of water heater being replaced, hot water consumption and fuel tariff. Maximum financial savings off your hot water bill are achievable when replacing an electric water heater on continuous tariff

To obtain a quote on this product

Call Rheem on


Ready to buy a Rheem?

For help to make the right choice, access our network of Rheem Approved Plumbers and Stockists.


Top Five Troubleshooting Topics


Please locate your model number, serial number and the date of manufacture, found here, for your Rheem hot water system and call Rheem on 1300 556 036.

Please see the Owner Guide for your Heat Pump model.

There are many fault codes that can be shown through the amount of flashing lights on the heat pump controller. They do vary depending on the unit, either 310L or 325L. You can locate the description of these fault codes by accessing your Owner's Guide and Installation Instructions here.

If your system continues to flash fault codes, please call Rheem Service to book a service call on 13 10 31.

The water temperature may be lower than usual due to heavy hot water usage. Also, this problem could be due to faulty tempering valve that is excessively cooling your hot water. Your local approved Plumber can test your system and replace the valve if necessary. To find your local Rheem Plumber, contact us  or call Rheem on 1300 556 036.  

Do you have a solar water heater? Check that the booster is being used as per the installation instructions for your model. If you have a timer installed, you will need to ensure that sufficient time is allowed to heat enough water to meet your household’s hot water needs

If you have a 50°C temperature limited water heater, then hot water to your whole house will be limited to 50°C

For showers to operate correctly, it’s necessary to store your hot water at a minimum of 60°C. 

 

If your water heater is fitted with a temperature limiting valve and the water is hotter than it should be, please call Rheem on 1300 556 036.  

 

If your hot water is hotter than it should be and you don’t have a temperature limiting valve installed, then you could:

  • Have the thermostat on your water heater adjusted downward (with a gas storage water heater you can do this yourself). Please note that gas storage must be set no lower than 60°C and a gas continuous flow booster for a solar system must be set no lower than 70°C

     
  • Ask your plumber to install a 50°C temperature limiting valve

 

To find your local Rheem Plumber, contact us  or call Rheem on 1300 556 036.  


Is the gas connection only used for the Water Heater?

Please, select all the fields

Running Cost Estimator Disclaimer as at 23/10/2017

Things that you should know about the Rheem Running Cost Estimator

The estimator is provided as a guide only to help you compare estimated running costs between various water heater types.

The estimator is based on Australian Standard AS5263, which relies on certain assumptions, such as an average daily load of 200L and 19 tap turns. Your situation and usage may be different to these assumptions, so the estimator may not match your actual daily loads and pattern of use.

Accordingly, the estimator cannot and does not purport to provide an accurate assessment of your yearly hot water energy bill. It does, however, allow a reasonable comparison between various water heater types based on Australian Standard AS5263 and average fuel tariffs used in the estimator.

Your state has been used to determine the temperature rise required to heat water from cold to a temperature of 65C, the applicable charge for the tariff type selected and the amount of solar savings.

Solar savings are based on Australian Government approved modelling for the type of solar water heater selected and the booster type. All electric boosted solar water heaters are modelled with a continuous tariff, but may be suitable for use on other tariff types depending on the model selected, your climate zone and the amount and usage pattern of hot water use.

Tariffs are current as at 1st July 2017 and represent an average price for the fuel type for the capital city in the state or territory, including GST.

Fixed charges, system access charges, delivery fees and any other fees and charges, including special rates and discounts are excluded from the estimator.

Energy consumption figures used are for a typical water heater within a category and do not reflect a specific model. Actual energy use may vary.

Heat Pump and solar water heaters may be suitable for Off Peak/Shoulder Rate tariffs depending on the type of water heater selected and the location. You should consult with your energy provider or installer before making any decision.

RHE249 - Rheem Combined Brochure 01 March 2019 web

Brochure


Rheem Loline® 325L Solar Water Heater

Do your bit for the planet and save energy at the same time. It's designed for warmer climates and areas with good water quality.

Rheem Loline® 160L Solar Water Heater

The Rheem Loline 160L is a split system design installed at ground level, available in VIC and SA only.

Save when switching to solar


To install a Rheem, you'll need a plumber

Get in touch with your local Rheem Approved Plumber and ensure your install is done right.


Ready to buy a Rheem?

For help to make the right choice, access our network of Rheem Approved Plumbers and Stockists.