text.skipToContent text.skipToNavigation
install a
Rheem

MODEL NO: 874820
Rheem 20L Gas Continuous Flow Water Heater : 60°C
Hot water that never runs out. The Rheem 20L Gas Continuous Flow water heater is a compact, medium capacity model that's ideal for homes with limited space, small to medium sized apartments and townhouses.

Features at a Glance

Capacity (L)
20
No. of People
4
Energy Rating
6
Warranty
10 years
Features:
  • 60°C temperature model
  • 20L/minute continuous hot water delivery (at 25°C rise) – suitable for 2 bathrooms
  • Compact 520mm(H) x 355mm(W) x 187mm(D)
  • Flamesafe® overheat protection — shuts down the water heater before overheating can occur
  • Rheem Q Factor™ — ensures rapid hot water every time, with none of the fluctuations that occur with some continuous flow units
  • Remote temperature controller options — so you can set the best and safest temperature for the bathroom and kitchen
  • Natural gas and propane models available
Warranty:
  • 10 Years parts and 3 Years labour on Heat Exchanger
  • 3 Years parts & labour on other components, when installed in a domestic dwelling.
  • For all other installations, the warranty period is 1 Year parts and labour on Heat Exchanger and other components.
* Warranty conditions apply

Specifications

Running Cost Estimator

Running Cost Estimator Disclaimer as at 23/10/2017

Things that you should know about the Rheem Running Cost Estimator

The estimator is provided as a guide only to help you compare estimated running costs between various water heater types.

The estimator is based on Australian Standard AS5263, which relies on certain assumptions, such as an average daily load of 200L and 19 tap turns. Your situation and usage may be different to these assumptions, so the estimator may not match your actual daily loads and pattern of use.

Accordingly, the estimator cannot and does not purport to provide an accurate assessment of your yearly hot water energy bill. It does, however, allow a reasonable comparison between various water heater types based on Australian Standard AS5263 and average fuel tariffs used in the estimator.

Your state has been used to determine the temperature rise required to heat water from cold to a temperature of 65C, the applicable charge for the tariff type selected and the amount of solar savings.

Solar savings are based on Australian Government approved modelling for the type of solar water heater selected and the booster type. All electric boosted solar water heaters are modelled with a continuous tariff, but may be suitable for use on other tariff types depending on the model selected, your climate zone and the amount and usage pattern of hot water use.

Tariffs are current as at 1st July 2017 and represent an average price for the fuel type for the capital city in the state or territory, including GST.

Fixed charges, system access charges, delivery fees and any other fees and charges, including special rates and discounts are excluded from the estimator.

Energy consumption figures used are for a typical water heater within a category and do not reflect a specific model. Actual energy use may vary.

Heat Pump and solar water heaters may be suitable for Off Peak/Shoulder Rate tariffs depending on the type of water heater selected and the location. You should consult with your energy provider or installer before making any decision.