text.skipToContent text.skipToNavigation
install a
Rheem

MODEL NO: 511161
Rheem Loline® 511161 Solar Water Heater
The Rheem Loline 160L is a split system design with the 160 litre tank and solar continuous flow gas booster installed at ground level and one or two roof mounted collectors. Available in VIC & SA only. Installed with 1 x CSA2612 collector within the Regulation Compliance Zone in Victoria, it achieves compliance to new home legislation for water heating Outside of Compliance Zone 2 x LCS collectors should be used to achieve compliance.

Features at a Glance

Capacity (L)
160
No. of People
4
Warranty
5 years
Features:
  • 160L tank capacity is suitable for 2-4 people
  • 26 L/min in-series gas booster site integrated or installed remotely
  • Enhanced frost protection – Electronically controlled circulation of water prevents frost damage.
  • Suitable with 1 x CSA2612 collector orientated within 60° west or 30° east of magnetic north or 2 x LCS collectors orientated outside of this zone up to 100° west or 80° east of magnetic north in Victoria or 1 x CSA2612 collector in South Australia
 
Warranty:
Tank and Collector(s)
  • 5 years cylinder and collector supply*
  • 3 years cylinder labour*
  • 1 year colletor labour*
  • 1 year parts supply and labour
Solar Gas Booster
  • 10 years gas booster heat exchanger supply*
  • 3 years heat exchanger labour*
  • 3 years parts supply and labour
 
*Applies to an installation in a single-family dwelling only.
Amended warranty may apply where a government rebate (Victoria) has been received for the solar water heater. Phone 131 031 for details.

Specifications

Running Cost Estimator

Running Cost Estimator Disclaimer as at 23/10/2017

Things that you should know about the Rheem Running Cost Estimator

The estimator is provided as a guide only to help you compare estimated running costs between various water heater types.

The estimator is based on Australian Standard AS5263, which relies on certain assumptions, such as an average daily load of 200L and 19 tap turns. Your situation and usage may be different to these assumptions, so the estimator may not match your actual daily loads and pattern of use.

Accordingly, the estimator cannot and does not purport to provide an accurate assessment of your yearly hot water energy bill. It does, however, allow a reasonable comparison between various water heater types based on Australian Standard AS5263 and average fuel tariffs used in the estimator.

Your state has been used to determine the temperature rise required to heat water from cold to a temperature of 65C, the applicable charge for the tariff type selected and the amount of solar savings.

Solar savings are based on Australian Government approved modelling for the type of solar water heater selected and the booster type. All electric boosted solar water heaters are modelled with a continuous tariff, but may be suitable for use on other tariff types depending on the model selected, your climate zone and the amount and usage pattern of hot water use.

Tariffs are current as at 1st July 2017 and represent an average price for the fuel type for the capital city in the state or territory, including GST.

Fixed charges, system access charges, delivery fees and any other fees and charges, including special rates and discounts are excluded from the estimator.

Energy consumption figures used are for a typical water heater within a category and do not reflect a specific model. Actual energy use may vary.

Heat Pump and solar water heaters may be suitable for Off Peak/Shoulder Rate tariffs depending on the type of water heater selected and the location. You should consult with your energy provider or installer before making any decision.