text.skipToContent text.skipToNavigation
install a
Rheem

MODEL NO: 511271
Rheem Loline® 511271 Solar Water Heater

Do your bit for the planet and save energy at the same time! Go solar with the Rheem Loline® solar hot water heater. It's designed for warmer climates and areas with good water chemistry. If you need an emergency replacement, you can run this water heater on its electric boost until your collectors are installed.

Features at a Glance

Capacity (L)
270
No. of People
5
Warranty
5 years
Features:
  • 270L capacity tank is suitable for 2 - 5 people
  • The tank has a back-up electric booster to keep you in hot water when the sun isn't shining.
    Alternatively, you can choose to have a Rheem solar continuous flow gas water heater installed with the tank to provide boosting
  • Reduces energy use1,2
  • Limited frost protection – Electronically controlled circulation of water prevents frost damage
  • Suitable with NPT200 or LCS collectors
Warranty:
  • 5 year cylinder*
  • 5 year collector(s)
  • 3 year labour on cylinder
  • 1 year parts including labour.
*Applies to installation in a single-family domestic dwelling only. Amended warranty may apply where a government rebate (Victoria) has been received for the solar water heater. Phone 131 031 for details.
Warranty conditions apply.
1Energy reduction based on Australian Government Approved TRNSYS simulation modelling and apply when replacing an electric water heater with a Rheem solar water heater.
2Any financial savings will vary depending upon type of Rheem Solar system installed, orientation and inclination of the solar collectors, type of water heater being replaced, hot water consumption and fuel tariff. Maximum financial savings off your hot water bill are achievable when replacing an electric water heater on continuous tariff.

Specifications

Running Cost Estimator

Running Cost Estimator Disclaimer as at 23/10/2017

Things that you should know about the Rheem Running Cost Estimator

The estimator is provided as a guide only to help you compare estimated running costs between various water heater types.

The estimator is based on Australian Standard AS5263, which relies on certain assumptions, such as an average daily load of 200L and 19 tap turns. Your situation and usage may be different to these assumptions, so the estimator may not match your actual daily loads and pattern of use.

Accordingly, the estimator cannot and does not purport to provide an accurate assessment of your yearly hot water energy bill. It does, however, allow a reasonable comparison between various water heater types based on Australian Standard AS5263 and average fuel tariffs used in the estimator.

Your state has been used to determine the temperature rise required to heat water from cold to a temperature of 65C, the applicable charge for the tariff type selected and the amount of solar savings.

Solar savings are based on Australian Government approved modelling for the type of solar water heater selected and the booster type. All electric boosted solar water heaters are modelled with a continuous tariff, but may be suitable for use on other tariff types depending on the model selected, your climate zone and the amount and usage pattern of hot water use.

Tariffs are current as at 1st July 2017 and represent an average price for the fuel type for the capital city in the state or territory, including GST.

Fixed charges, system access charges, delivery fees and any other fees and charges, including special rates and discounts are excluded from the estimator.

Energy consumption figures used are for a typical water heater within a category and do not reflect a specific model. Actual energy use may vary.

Heat Pump and solar water heaters may be suitable for Off Peak/Shoulder Rate tariffs depending on the type of water heater selected and the location. You should consult with your energy provider or installer before making any decision.